Call (424) 331-9585

2006 Ford Mustang

//2006 Ford Mustang

2006 Ford Mustang

Ford Mustang

Mileage
206,126
Service Date
8/7/2020
Services Performed
  • Change engine oil and replace oil filter. Check air filter. Check readily accessible fluid levels and top off as needed. Check tire pressures and set to correct specification. Reset oil life & maintenance reminder light. Includes maintenance inspection, all noted maintenance items requiring attention will be noted on work order. Maintenance inspection does not include diagnosis for any sounds, warning lights, or other issues that are not readily visible or apparent.
  • HEATER HOSES – Remove & Replace – V6 One – [NOTE: Deduct .2 when used in conjunction with Radiator Hose(s) – R&R.]
  • PERFORMED DIAGNOSTIC INSPECTION AND FOUND ENGINE NOT CRANKING, NO SIGNAL TO STARTER. NOTICED NO ODOMETER READING IN INSTRUMENT CLUSTER. ATTEMPTED TO START VEHICLE BY MANUALLY APPLYING POWER TO STARTER MOTOR WITH KEY ON IN ATTEMPT TO BYPASS STARTING CIRCUIT. FOUND ECM UNABLE TO SUPPLY NECESSARY SIGNALS TO FUEL INJECTORS AND IGNITION COILS. NEXT STEP IS PIN CHECK ECM AND VERIFY ALL SIGNALS IN AND OUT OF ENGINE COMPUTER TO DETERMINE IF ENGINE COMPUTER IS FAULTY.
  • PERFORMED PIN CHECK OF ECM TO TRACE SIGNALS TO AND FROM ECM, AND ALSO PIN TEST TO VERIFY SIGNALS FROM SMART JUNCTION BOX TO ECM AND FOUND ECM POWER RELAY UNABLE TO RECEIVE POWER SUPPLY WHICH WOULD IN TURN POWER ECM. ECM POWER RELAY RECEIVES SIGNALS FROM SMART JUNCTION BOX, SMART JUNCTION BOX WAS UNABLE TO SUPPLY POWER TO ECM RELAY LOCATED IN THE ENGINE COMPARTMENT. DIODE WAS REPLACED, VEHICLE STARTED, ALL COMPUTERS WERE RESET AND VEHICLE IS STARTING RELIABLY AT THIS TIME.
  • REPLACE LUBE STICKER AND ENGINE COVERS
  • RESET VEHICLE MAINTENANCE REMINDER
  • SPARK PLUGS – Remove & Replace – V6
  • STABILIZER BAR CONTROL LINK – Remove & Replace – Both Sides
  • THERMOSTAT &/OR GASKET – Remove & Replace – V6 UPPER AND LOWER HOUSING
 
KATHERINE H. gave our service a 5 star review on 8/10/2020
2020-08-11T22:00:43+00:00